大发体育

Electrically and Frequency-Tunable Printed Inverted-F Antenna with a Perturbed Parasitic Element

Article information

J Electromagn Eng Sci. 2020;20(3):164-168
Publication date (electronic) : 2020 July 31
doi :
Department of Radio and Information Communication Engineering, Chungnam National University, Daejeon, Korea
*Corresponding Author: Jong-Myung Woo (e-mail: jmwoo@cnu.ac.kr)
Received 2019 June 25; Revised 2019 August 05; Accepted 2020 March 05.

Abstract

This study designed an electrically and frequency-tunable printed inverted-F antenna (PIFA) with a perturbed parasitic element between the antenna and the ground plane. The resonant frequency of the proposed antenna can be changed via the short- and open-circuit operation of the parasitic element. This operation is activated using an electrical switch, which in this case is a PIN diode with an inductor and a resistor. The antenna was designed on the basis of the principles of the perturbation method, which enables control over resonant frequencies through modifications to the volume of a metal cavity. Meandered gaps were incorporated into the parasitic element for the independent operation of each PIN diode switch. The size of the PIFA’s radiator is 4.8 × 10 mm2, and the tunable resonant frequency at the –10 dB bandwidth is 340 MHz (17.3%).

I. Introduction

Recent developments in mobile communication technology gave rise to a bandwidth requirement of 300 MHz (11.7%) for the 3.5 GHz frequency band used for 5G technology. To meet this requirement, developers created many multiple-input, multiple-output antennas, which are mainly used in mobile communication [1, 2]. These antennas, however, need additional space for multiple ports, making it difficult to satisfy the required bandwidth with a single antenna port in a given space. This problem was overcome through the development of frequency-tunable antennas. A variant of these innovations is the two-dimensional printed inverted-F antenna (PIFA), which is widely used in electronic devices as a communication antenna [3]. It can be easily fabricated through modern printing technology and fitted into a limited space because of its low-profile structure. Another example is the frequency-tunable planar inverted-F antenna equipped with a capacitor [47] (see also [8]). The capacitor is located between the main radiator and a parasitic element to vary resonant frequencies, after which capacitance is modified. This design means that the space occupied by a complex feeding structure expands because the antenna is directly connected to the radiator and parasitic element. An important consideration, however, is that using different capacitance values can contribute to antenna losses.

Previously developed frequency-reconfigurable antennas are equipped with yttrium-iron-garnet elements, and their resonant frequencies are tuned by changing the magnetic field, which is controlled by a DC bias [9]. The drawback to this design is that it reduces an antenna’s radiation efficiency and increases fabrication costs.

In the present study, a frequency-tunable PIFA (FTPIFA) comprising a perturbed parasitic element was designed, with mobile devices as reference. The size of the antenna was reduced on the basis of perturbation theory [1012] to the radiation element. The resonant frequency of the PIFA can be tuned by changing the volume of the electric and magnetic fields.

II. Antenna Design

Fig. 1(a) and (b) show the designed PIFA with a parasitic element between the radiator and the ground plane. It was printed on a 0.8-mm thick, 50 × 100 mm2 FR-4 (ɛr = 4.3, tanδ = 0.025) substrate. The size of the antenna’s radiator is 24.8 × 10 mm2. Because the position where a short circuit occurs (“short position” hereafter) can be tuned from switches #1 to #5 by using a copper strip, the central frequency (2,045 MHz) is based on the shorted state of switch #3.

Fig. 1

(a) FTPIFA with basic perturbed parasitic element, (b) perturbed parasitic element, and (c) perturbed parasitic element with PIN diode switch.

Fig. 1(c) illustrates the new antenna structure used to change the short-circuit structure of the copper strip (Fig. 1(b)大发体育). A PIN diode (SMP1345-079LF) located between the parasitic element and the ground plane functions as a switch. It was redesigned by adding meandered gaps to the parasitic element for DC blocking and the independent operation of each switch.

The principles used to design the antenna are those underlying the perturbation method [11], through which resonant frequency can be controlled by changing the volume of a metal cavity (Fig. 2 and Eq. (1)大发体育). This method is also commonly used as reference in miniaturizing antennas.

Fig. 2

大发体育Perturbation principle: (a) original metal cavity and (b) perturbed metal cavity.

(1) ω-ωoωoΔτ(μ|Ho|2-ɛ|Eo|2)dττ(μ|Ho|2+ɛ|Eo|2)dτ

where ωo is resonant frequency; Eo, electric field; and Ho大发体育, magnetic field.

Fig. 3大发体育 presents the fabricated prototype antenna.

Fig. 3

Fabricated prototype antenna.

III. Simulation and Measured Results

Fig. 4 shows the FTPIFA’s S1, which was measured from the short-circuit operation of short positions #1 to #5 to verify changes in the resonant frequency of the antenna. Also Fig. 4 indicates that the resonant frequency decreased as the short position moved from #1 to #5 and that the central frequency (2.1 GHz) was determined when switch #3 was shorted. Because of the extent of the electric field, the magnetic energy between the antenna and the ground plane was changed by the short-circuit operation and on the basis of the perturbation principle [3]. In other words, the resonant frequency increased because of the reduction in the volume of the magnetic field energy near the feeding point when position #1 was shorted. Conversely, the resonant frequency decreased because of the reduction in the volume of the electric field energy at the edge of the radiated element when position #5 was shorted.

Fig. 4

Short position-based S1 of the FTPIFA with a perturbed parasitic element.

The electrical operation of the shorted position was realized by applying a DC bias to the PIN diodes. An inductor (22 nH) for AC cut-off and a meandered gap on the parasitic element for the independent operation of a switch were also used. Fig. 5 shows the S1 measured from the operation of switches #1 to #3, which were manipulated by turning a PIN diode on and off to determine changes in the antenna’s resonant frequency. The number of switches was limited to three for equal intervals of frequency movement. When switch #1 was on, the upper frequency was resonant, but when switch #3 was on, the resonant frequency decreased given the change in the volume of the electric field energy. The measured −10 dB bandwidth covers 1.83 to 2.17 GHz, and the total tunable resonant frequency is 340 MHz (17.3%).

Fig. 5

Electrical switched-measured S1大发体育 of the FTPIFA.

Fig. 6 shows the radiation patterns measured at each resonant frequency of the antenna prototype when the switches were on. The H-plane patterns of the vertical element that indicates directivity to the x-axis are shown in Fig. 6(a), and the H-plane patterns of the horizontal element overcoming a null point are displayed in Fig. 6(b). As can be seen, the designed antenna could maintain the radiation patterns of a basic inverted-F antenna, regardless of switch position.

Fig. 6

Radiation patterns measured on the basis of short positions: (a) xz-plane (Eϕ) and (b) yz-plane (Eϕ).

Fig. 7大发体育 shows the simulated and measured peak gains when each switch was on. The simulated and measured average realized gains were 3.0 dBi and 3.1 dBi, respectively, pointing to a reasonably good agreement between the simulation and measurement.

Fig. 7

Peak gains measured using an electrical switch: (a) simulation and (b) measurement.

Finally, Table 1 summarizes the measured total efficiency and peak gain of the designed antenna at resonant frequencies. These amounted to 88.0% and 3.44 dBi at 2.02 GHz, respectively, when all the switches were off. When the switches were activated (switched on) sequentially, the measured total efficiency was 72.0% for switch #1, 68.9% for switch #2, and 56.2% for switch #3.

大发体育Total efficiency levels and peak gains of the designed antenna

IV. Conclusion

An FTPIFA with a perturbed parasitic element was developed in this study. The designed antenna could be easily modified via the short- and open-circuit operation of the parasitic element between the antenna and the ground plane. It was redesigned by incorporating a gap capacitor into the parasitic element for the independent operation of each switch. As the resonant frequency varied considerably at the end of the radiator, a non-linear interval was arranged in the parasitic element. The antenna could also maintain the radiation patterns of a basic inverted-F antenna, regardless of switch position, and could be easily changed without loading and tuning the chip element on the antenna. Therefore, it is fully applicable to 5G technology and can selectively achieve the frequency band necessitated by an allocated frequency bandwidth.

References

1. Zhu L, Hwang HS, Ren E, Yang G. High performance MIMO antenna for 5G wearable devices. In : Proceedings of 2017 IEEE International Symposium on Antennas and Propagation & USNC/URSI National Radio Science Meeting. San Diego, CA; 2017; p. 1869–1870.
2. Abdullah M, Ban YL, Kang K, Li MY, Amin M. Compact four-port MIMO antenna system at 3.5 GHz. In : Proceedings of 2017 IEEE 2nd Advanced Information Technology, Electronic and Automation Control Conference (IAEAC). Chongqing, China; 2017; p. 656–660.
3. Lee HS, Woo JM, Kim JC. Printed type inverted-F antenna. In : Proceedings of 1999 KEES Microwave and Electromagnetic Wave Communication Conference. Gwangju, Korea; 1999; p. 253–256.
4. Lim JH, Song CW, Jin ZJ, Yun TY. Frequency reconfigurable planar inverted-F antenna using switchable radiator and capacitive load. IET Microwaves, Antennas & Propagation 7(6):430–435. 2013;
5. Nguyen VA, Dao MT, Lim YT, Park SO. A compact tunable internal antenna for personal communication handsets. IEEE Antennas and Wireless Propagation Letters 7:569–572. 2008;
6. Liu L, Rigelsford J, Langley R. Tunable multiband handset antenna operating at VHF and UHF bands. IEEE Transactions on Antennas and Propagation 61(7):3790–3796. 2013;
7. Balanis CA. Antenna Theory: Analysis and Design 3rd edth ed. Hoboken, NJ: John Wiley & Sons; 2005. p. 197–204.
8. Aberle JT, Oh SH, Auckland DT, Rogers SD. Reconfigurable antennas for wireless devices. EEE Antennas and Propagation Magazine 45(6):148–154. 2003;
9. Pozar DM, Sanchez V. Magnetic tuning of a microstrip antenna on a ferrite substrate. Electronics Letters 24(12):729–731. 1988;
10. Harrington RF. Time-Harmonic Electromagnetic Fields New York, NY: McGraw-Hill; 1961. p. 317–319.
11. Song MH, Woo JM. Miniaturisation of microstrip patch antenna using perturbation of radiating slot. Electronics Letters 39(5):417–419. 2003;
12. Kim YR, Woo JM. Electrically tunable small microstrip antenna using interdigital plate loading for telemetry sensor applications. Electronics Letters 48(8):422–423. 2012;

Biography

Yoon-Seon Choi

received her B.S. and M.S. degrees in radiowave engineering from Chungnam National University in 2014 and 2016, respectively. She is currently working toward her Ph.D. degree at the antenna laboratory. Her main research interest is antennas.

Ji-Hun Hong

received his B.S. degree in radiowave engineering from Chungnam National University in 2018. He is currently working toward his M.S. degree at the antenna laboratory. His main research interest is antennas.

大发体育Jong-Myung Woo

received his B.Sc. degree in electronics engineering from Konkuk University in Korea and Ph.D. degree in electronics engineering from Nihon University in Japan. He is a professor of Department of Radio and Information Communications Engineering in Chungnam National University in Korea. He is mainly interested in antennas.

Article information Continued

Fig. 1

大发体育(a) FTPIFA with basic perturbed parasitic element, (b) perturbed parasitic element, and (c) perturbed parasitic element with PIN diode switch.

Fig. 2

大发体育Perturbation principle: (a) original metal cavity and (b) perturbed metal cavity.

Fig. 3

Fabricated prototype antenna.

Fig. 4

Short position-based S1 of the FTPIFA with a perturbed parasitic element.

Fig. 5

Electrical switched-measured S1 of the FTPIFA.

Fig. 6

Radiation patterns measured on the basis of short positions: (a) xz-plane (Eϕ) and (b) yz-plane (Eϕ).

Fig. 7

大发体育Peak gains measured using an electrical switch: (a) simulation and (b) measurement.

Table 1

大发体育Total efficiency levels and peak gains of the designed antenna

Resonant frequency (GHz) Total efficiency (%) Peak gain (dBi)
All switches off 2.02 88.0 3.22
Switch #1 on 2.04 72.0 2.20
Switch #2 on 1.96 68.9 2.17
Switch #3 on 1.90 56.2 1.47